Interested to Buy Any Domain ? << Click Here >> for more details...
a distribution transformer(3 phase)supplying 440volt per
phase.now suppose one of phase voltage(230volt) becomes
zero.what will be the cause ?
- 3 Answers
- 5667 Views
- I also Faced
- E-Mail Answers
Answer Posted / akash`
check your high tension line d.o.if three d.o. is ok then
substation problem not coming one phase means single phasing
problem call it
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is the slip speed?
What does the letter CTNM in negative phase sequence relay means?
why the rotor current becomes in steady state during high slip region? please verify with equations.
what is distribution board?
Write the force balance equation of ideal spring element.
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
What is the drawback of class b amplifier?
What is the difference between the impedance percent and impedance voltage ?
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
boiler is running in rankine cycle and deisel generator is....?
does any one know where we can purchase insulation oil for high voltage oil filled cables
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
how to calculate power consumption in slip ring motor at different step
please explain how to do 'pole drop test' on generator?
