Interested to Buy Any Domain ? << Click Here >> for more details...
Why voltmeter is not connected in seris & ammeter connected
in parallel ?
- 5 Answers
- 27995 Views
- I also Faced
- E-Mail Answers
Answer Posted / nithi
if u connect the voltmeter in series, there is no power to
the later stages (like the source having high internal
resistance).
if u connect the ammeter in parallel,there is a dead
short circuit of the source(if fuses used,blown-off &
chance of ammeter coil damage).
| Is This Answer Correct ? | 24 Yes | 8 No |
Post New Answer View All Answers
Why we are going for converter transformers for DC drives application instead of distribution transformer?
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
what transformer we used normally and upto which kva?
what is the effect of back reactive power on the generator ?
How to calculate the heat load for a electrical room
Describe the control mechanism of missile launcher???
what is tri state logic gate
What is a fuse? How does it work? What are materials used?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
what is the difference between 2 way and 4 pole selector switch???
how to determine ct ratio in ht vcb?
