Interested to Buy Any Domain ? << Click Here >> for more details...
why the frequency in india is 50 50HZ why we not select the
o ther frequncy range?
- 6 Answers
- 9966 Views
- I also Faced
- E-Mail Answers
Answer Posted / veerendra shah
higher frequency give us higher output voltage ,india frequency selected 50hz if we select higher frequency then must be primemover speed more than 3000rpm . Above its speed only obtain by high temp.and pressure of steam.but indian metalorgy not take this temp.and pressure. if we given this then metal are melted.and also higher speed give higher centrifugal force on rotor .so causes india freq.50hz selected
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
how choose conductor&depending upon load
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
What are high pass filter and low pass filter? and What are the flowmeter ?
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
wow to calculate the transformer rating(KVA)
What is the mmf,rgt and ngt please brief completely
I have experienced electrical maintenance HT ,but I completed be ECE ....can I apply c license or not ???? Pls help me friend s...
list of tests to be carried out at manufacturers end while purchasing a step up transformer of 11kv to 66kv ,2MVa Capacity.
why u r living from presentaly working.
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
Explain the operation of grid connected central solar inverter ?
What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?
What is difference between start imitation and start interlock for 3 phase motor protection ?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
