Interested to Buy Any Domain ? << Click Here >> for more details...
why 1.25 factor is to be multiplied to cylindrical strength
of concrete while getting the equvalent cubical strength of
concrete?
- 10 Answers
- 22683 Views
- I also Faced
- E-Mail Answers
Answer Posted / b.srinivasarao
generally cylindricalstrength is equalto cube strength,
when cylender height to dia. ratio is 2:1, because
correction factor for cylindrical strength is
f=0.11n+0.78, where n=HEIGHT OF CYLINDER/DIA.OF CYLINDER.
SO IF H/D RATIO VARIES CORRECTION FACTOR ALSO VARIES
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What is .Dwg?
What are the benefits of rcc pipes over steel designed pipes?
if in column reinforcement lower dia connect to higher dia then from wher we want to start higher dia steel
How good are the Weinerberger Porotherm bricks that are being used in construction in Chennai, India. Its being used in non load bearing walls and has a compressive strength greater that 35 kg/cm^2 and a density of approx.694 - 783 kg/m3.
Why was the empire state building made of steel?
What are the advantages of cad?
how lap length is increased with increase of Grade of steel?
how do i remedy a foundatiom that the column bases was cast and aftet 28days crushing the conprehensive strength of the concrete fall below the specification 25N/mm2
why building got air crack? if it get in one particular are what is means?
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
how the calculation occurs if i want to mix 1cum of M50 concrete. please calculate every ingredients with detail calculation.
what is the design procedure for building
what is constat for brickwork
why the cracks occurs in NP3 class Hume Pipe ? And what is bearing capacity of it?
why we use for testing of compression strength concrete the size of specimen 150x150x150. why we are not using another dimension like 100x150x100 uneven dimension.
