Interested to Buy Any Domain ? << Click Here >> for more details...
Why voltmeter is not connected in seris & ammeter connected
in parallel ?
- 5 Answers
- 28204 Views
- I also Faced
- E-Mail Answers
Answer Posted / qureshi majid
The voltmetre is used for measuring the electrical potential
difference between two points of a line,where as the
potential difference measured between two points of same
wire/line is zero.In short!the internal resistance of
voltmetre is generally high,so you cannot connect it in series.
The ammetre having minimum internal resistance,supports the
idea of connecting it in series,because you want to measure
the current of a wire and current is same in a circuit
connected in series.The net effect is that the setup of
equipment discussed above does not affect the circuit behaviour
| Is This Answer Correct ? | 18 Yes | 9 No |
Post New Answer View All Answers
Which type of motor is used in trains, what is the rating of supply used explain working principal?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
Transformer how to maintaince a check b check c check d check
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
please send me privious exam's queation papers of section engineer(electrical).
I am B.E.electrical engineer having 7 years of experience in Transformer testing upto 315 MVA.I want to khow how I can get the 'Electrical Valuer' License.
what is control supply rating of a machine
What is the power factor of a transformer at no load?
What is the capacitance values of 132,220,400 & 765 kV current transformer
what are problems caused by the pdu in rack server
I am EEE student i want to improve my core side skills.how cn i approach it?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
where reactive power is used
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
