Interested to Buy Any Domain ? << Click Here >> for more details...
Why the stator is rotated in ceiling fans not Rator?
- 3 Answers
- 12754 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The rotating stator or armature is called ,the rotor.In
ceiling fan ,the rotating armature is outside to accommodate
large wings and to economize as the number of poles are more
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
what is the difference between RMS & TRUE RMS VOLTAGE
Y phase plates are used in transmission line??? what is there need???
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
what are the applications of transistors with low dc gain, high dc gain and medium dc gain( beta)?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
What is difference between start imitation and start interlock for 3 phase motor protection ?
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
what is a bus riser in power system and why it is used
how to decide no of electrodes for 1600A LT Main incomer panel
Can you explain about pole discrepancy scheme
What is lc oscillator?
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
