Interested to Buy Any Domain ? << Click Here >> for more details...
Do you know how to joint the H.T and L.T Cables?
- 23 Answers
- 64355 Views
- KESC, MGVCL, Nokia, Oil Country Tubular, Power Control, SAGT, Siemens, Simco, Vivek Engineers, I also Faced
- E-Mail Answers
Answer Posted / surya
i agree with gobi but with little addition vinothbhabu
in ht cable jonting one more jont is their that is compound
joint thid is also good method for ht cables
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
what is reactive power?, why its measured in VA ? is it transient behavior of system?
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
What happens to a motor if it is connected in Delta connection
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
how we will deside the high voltage value
does a DG set has low fault level as compared to that of a transformer.If yes then why.
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
Why does inductive loads consume KVARs?
how to control the speed to switched reluctance motor
What is stepper motor. What is its uses?
how withstand of hi-pot test outputs of transformer wire 2.5mm
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
How can find thermal state value in relay for calculate thermal overload.
