what is radar type level transmitters and its basic
principle and how to calibrate it
- 4 Answers
- 19154 Views
- ABB, Inovonz, I also Faced
- E-Mail Answers
Answer Posted / mohamed yousuf(instrumentation
radar type level transmitter works on the principle
of "time of flight system " actually this type of
transmitter having antenna used to send and recive the
micro waves these waves having the frequency range in GHZ.
by calculating the time required to send and recieve the
data the distance can be calculated from the following
expression
velocity=2 distance/time
therefore distance =velocity *time /2
for zero level 4ma and for span 20ma has to set
| Is This Answer Correct ? | 30 Yes | 2 No |
Post New Answer View All Answers
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
I want to apply for the universities in US,but i got the GRE score of (650+300=950)TOEFL 69/120.Is this score sufficient for applying universities please i am married i need to go to US because my husband didn't get H1 yet.please send me suggestion
What is cut off relay? And why use in PLC and DCS?
What is zener diode? What is voltage regulator?
pls give me presant awerness quistion and answer in my emailid.
flow transmitter formula?
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
what is gas metering system? gas chromatograph? and gas compressors?
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
anybody having Qatar Petroleum questions for instrument Technician offshore ....please send me
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
