transformers parts & function of each parts
Answer Posted / syed.yaseen
parts are:
a) primary winding,
b secondary winding
c) bucholes Relay
d) air vent
e) breather
f) oil
g) radiator
h) ht & lt bushes,
i) tap changer
j) silica gel
k)Winding temperature gauge
l)oil temperature gauge
Is This Answer Correct ? | 467 Yes | 49 No |
Post New Answer View All Answers
What are the material used for resistor?
How to decide DO set rating of Transformer?
what is charger supervision and control supervision?
XYZ
Is better to supply the voltage for static exciter from the auxiliary power source or from the SG terminals? And why?
What is steady state response?
How much dc volt applied in cathodic protection system?
what is induction furnance? how many phase supply given io its coil for 15 or 20 ton furnance?
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.
How many types of electrical earthing are there?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
Write a note on Treatment for electric shock.
i need mat lab program to find out the transmission line losses,regulation and losses
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.