Interested to Buy Any Domain ? << Click Here >> for more details...
what is the procedure to isolate flow a transmitter and
flushing it?
- 8 Answers
- 42216 Views
- Petrofac, I also Faced
- E-Mail Answers
Answer Posted / sajid
if its a orifice type flow transmitter it must have a 3 way
or way manifold..
in 3 way manifold 2 isolation valve and 1 equlisation valv
will be there..
open the equalisation valve and make sure that DP is 0..
then close low pressure and highpressure valve
| Is This Answer Correct ? | 15 Yes | 15 No |
Post New Answer View All Answers
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
How flow can be measured with dp?
How to Calibrate Level Switch in field
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
Explain PID controller tuning & any one method used for it.
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
detail of mass flow meter pricipal
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
Describe the function of Accumulator into the Pump
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
What is Positive Calibration and Negative Calibration?
