Answer Posted / fazal ur rehman
Yes, Hm is absolutely right
Purpose of earthing is to provide a low potential path to
fault current which result in tripping the protective
device & thus cut off the supply. Once the supply is cut
off, both equipment & operator is safe. But remember
earthing witout the use of protective device in the circuit
is of no use.
Is This Answer Correct ? | 15 Yes | 3 No |
Post New Answer View All Answers
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
wat is meant by PX class in ct?
What is the function of NGR for the parallel operation of alternator? whats happen when different rating of alternator are running with parallel?
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
What is the operating principle of turbo-generator.
Operation carried out in thermal power stations?
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
What if high voltage side circuit breaker of a ehv transformer instead of lvcb? Kindly elaborate.
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?