Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between scaler and vector control in
drive and where it is to be used ?
- 1 Answers
- 13856 Views
- Essar, TCS, I also Faced
- E-Mail Answers
Answer Posted / g senthilkumaran
Scalar drive means only V/F control over the motor
torque can control by V/F mode
Vector control drives use a mathematical model of the motor
to dynamically determine the values of the essential
operating and control parameters. They are called "vector
control" drives because this analysis is based on a vector
representation of current, voltage and magnetic flux.
Vector drives continuously monitor and analyze the motor
current to determine what voltage to apply at any given
frequency to produce the optimum magnetizing current.
Vector drives provide excellent performance in terms of
accurate static and dynamic speed regulation and rapid
response to sudden changes in load torque
| Is This Answer Correct ? | 21 Yes | 4 No |
Post New Answer View All Answers
Safety of dry type transformer
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
How much of the total hydro power potential has been exploited so far in india?
WILL SCHNEIDER MAKE ACB(MASTERPACT)TRIP ON REVERSE POWER?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
what will happen if i connect 12 volt battery with 24 volt battery charger.
Difference between transition and diffusion capacitance
how to calculate percentage impedence at 75 deg C at normal tap
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
Define what is difference between fuse and breaker?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.
