Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / chinmaya
VFD is variable frequency drive.It is used for regulating
the RPM of a motor by regulating it's frequency.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
can i able to get bhel previous exam question paper?
what is the terminal voltage of dc series generator running at rated speed at no load?
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what are the applications of transistors with low dc gain, high dc gain and medium dc gain( beta)?
What is the diff. between single compression and double compression gland
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
What happens if i apply 500V to 440V rotary Switch ?
Define reserve-generating capacity?
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
how can check the resistance of battery contact?
Give two basic speed control scheme of dc shunt motor?
Why to keep capacitor bank off while generator running.
