how u measure flow?orifice measurement?why all ft in square
root?
- 1 Answers
- 6376 Views
- I also Faced
- E-Mail Answers
Answer Posted / manoj kumar
There are several ways to measure the flow of fluid & gas
like magnetic flow meter, mass flow meter, based on
measurement of differential pressure like venturi, orifice
etc, turbine flow meter, positive displacement flow meter,
vortex flow meter.
Measurement of flow with the help of orifice is based on
the measurement of differential pressure across the orifice
plate. Tappings are either on the supporting flange or at D
& D/2 m away for upstream and downstream of the orifice
respectively where D id Pipe diameter in which plate is
installed.
Not all the transmitters are square root.Those transmitters
which are based on differential pressure are square root.
We can use square root at the transmitter itself or we can
make the calculation in the DCS/PLC program.
Since Q(flow) is directly proportional to square root of
the differential pressure we do the square root extraction
to measure the flow.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
Draw bode plot of any transfer function. Why is plotting bode necessary?
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
what is 24vdc live and dry supply
Which is your favourite subject & explain any one topic of it.
flow transmitter formula?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
Questions on flow meters,few questions on HART protocol,
whatis range of marcury filled tempereture gague
Why do you want to work here
What is standard procedure of manual mapping in Radar type level transmitter?
how to calibrate corollaries (Mass flow meter)?
