Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the earthing resistance of an industrial
substation and also What should be the house hold earthing
resistance?
- 20 Answers
- 113589 Views
- Jindal, Pharma, TAAT, TATA, I also Faced
- E-Mail Answers
Answer Posted / ranjeet
For house hold maximun value of earthing can be 4
ohms.But for a substation it should be less than 1 ohms.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
what is the difference between elcb and rccb ?
What is the real function of reverse power relay in generator panel while syncronising?
What is safety of Ht panel
Discribe type of fault in DOL and stardelta startor.
Batteries. What is the difference between Lead and Nickel batteries ?
how to calculate the conductor size for certain KV transmission line and distribution line?
i am completed my degree(B.E EEE) 2014 anychance to get electrical licence plz help me
Why 1/3 is used in symmetrical components?
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
On 400 amp factory load how kvarh capacitors provide
what are the range of memory address in plc for L&T lx7 4A
how we can calculate the efficiency of a diesel generator ?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
