why 4-20 mA signal is preferred over a 0-10V signal
- 17 Answers
- 71205 Views
- Sofcon, I also Faced
- E-Mail Answers
Answer Posted / luki satria
4-20mA can be easily detected for find a minimum and maximum
level measurement. in in 0-10 V some noise if we are not
prepared measurement
| Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
How many interlocks at turbine? Plz explain briefly
What is the main difference between Cavitation and Flashing?
How will you test a transistor with a multimeter?
Explain the difference between mmwc and mmwg?
What is the use of each wire in three wire RTD
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
Calibration procedure for Electro magnetic Flow meter
define feed forward control loop with example and drawing?
How to work temperature gauge?
How digital input and digital output 's are working in dcs
what is your eligibility criteria for freashers?
Square root calculation for dp flow transmitter?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
what is the calibration procedure for magnetic flow meter @ onsite
