Answer Posted / meenakshi
Stray or ghost voltages occur from capacitive coupling,
which takes place between energized circuits and non-
energized non-connected adjacent wiring.
practical occurance : When facilities or buildings are
built and wired, it's very common for the electricians to
pull extra wire thru the conduit for future use. These
wires are typically left unconnected until needed.at this
situation coupling effect takes place as explained above.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how ct burden,magnetising current,ratio and knee point voltage are related & derived
how to calculate the tarriff for an industry whose kva demand is 10 mva
What are the types of transformers according to the arrangement of iron cores?
What is creepage distance..... what will be the value for different voltage level
aternator every parts and its working
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
what is the necessity of under ground cables ??
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
Explain how to determine capacitor tolerance codes?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
explain different types of d.c motors?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
HOW CAN YOU CALCULATE PRACTICAL EFFICIENCY OF A ASYNCHRONOUS INDUCTIONMOTOR OF 7.5KW,& MOTOR IS RUNNING WITH AVOLTAGE OF 410 VOLTS,& TAKING CURENT OF 13 AMPS
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle