Why 60Hz motor taking more current on load in 50Hz power
supply?
- 1 Answers
- 4861 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Probably due to higher speed.
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
How would your past experience translate into success in this job?
we have amp, voltage, kw, length detail then how to calculte copper & alluminium size of conductor of 3-phase induction motor
What about electrical Units. discrive in detail
low frequency protection why recomend?
sir, 3phase induction motor takes different pf and different KW in three phase while running,explain reason
what is dry and wet frequency withstand voltage? why & where it is used??
Explain thin film resistors and wire-wound resistors
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
is it possible to have dc motors on single chip
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
what is the principle of operation of CFL ??
How to use computer cpu ups use for home inverter circuit board
can we use NPT glands in LT panel
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
