Explain Difference between Bech set and operating range of
control valve
Answer Posted / rakesh kumar.n be
if u do the adjustment in the string at the actuator, or
compress the spring, u will get the opposing force to move the
stem in the control valve that is called bech set .it depents
on the control valve. mostly foe small valve we use 3-15 psi
and for medium we use 6-30 psi .thanks
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Difference between dcs and plc including date processing and architecture.
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
What is first echo & echo window in radar type level transmitter?
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
how to check earthing,what is minum ohms for proper earthing
why we are using magnet for calibration of gas detector?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
what is wave length were using ?
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
How signals can be taken through modbus?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
in mass flow meter what is drive friquancy ?