Answer Posted / samir rana

cu lossof x mer depends on current and iron
loss on voltage total x mer loss depends on va and not on
phase angle between v and i it it is independent of load
power factor. that is why rating og x mers is in kva and
noy in kw.

What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.

1775

---

How can we measure the residual voltage in dc machines?

1858

---

what are factors to be consider in electrical installation like load factor,diversity factor .....

1802

---

Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you

1714

---

How to calculate cable size by using load.?? Any formula...

1378

---

What are the special cables required for explosion proof wiring?

16688

---

hi plz send me reliance placement papers..i.e electrical technical papers that have been asked in reliance test.

2956

---

Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?

1937

---

What is transient Phenomenon?

2244

---

Do Phase angle measurement have any application in freq/harmonics measurement? If so how?

1932

---

If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.

1429

---

Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards

2103

---

Define active filter?

1016

---

I Just want do EHS Certified Certification Distance Course From Govt approved,so can any body provide me details.

2130

---

I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok

1665

---