Interested to Buy Any Domain ? << Click Here >> for more details...
deference between DCS and PLC including date processing and
architacture.
- 11 Answers
- 19933 Views
- Jindal, Shell, I also Faced
- E-Mail Answers
Answer Posted / rakesh kumar .n be
PLC will have faster date processing then dcs..... PLC will send the date 50ma while DCS will 500ma.... it is not the accurate valve it is the bacic difference.
according to the Architecture PLC is easy but DCS is difficult, but DCS is good because in DCS we use HPM->HPMM->FTA->FCS->Field (redundancy is good in DCS)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the difference between profibus and controlnet networking.
Why plc require in analog input 4-20amp & 0-10 volt?
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How to interfacing microcontroller with a DC motor
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
How does a single acting, spring return ball valve actually work? Does it require continuous air supply?
Why MUX JB's are using only Temperature Element in Fundation field bus?
TEMPERATURE VARIATION FOR FREQUENTLY.
in mass flow meter what is drive friquancy ?
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
what is sil (safety integrity level
Square root calculation for dp flow transmitter?
