How would you supply power to a village which is very far from
a sub-station and has only a 11kV line running near by?
- 3 Answers
- 5177 Views
- I also Faced
- E-Mail Answers
Answer Posted / subu ravichandran
take a tapping from 11 kv feeder and bring it near by the village with help of overhead lines. then with help of a distribution transformer(11kv/415V) tap it and supply it to the village.depending on your village load select transformer rating.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
Define sensitivity?
why Lightening Arrester Probe sharp at Top of telecom tower.
What is the exact formula for one weber of magnetic flux?
What is Scheme Test of High Voltage Switchgear. Which tests it includes.
what is th basic difference between a d latch time line and a d flip flop time line???
what is the requirement regarding earthing of Single conductor with AWA
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
what is the AC Plant and how can do the work with parts and picture tell us 150 Tr
sir, i am 3 years diploma course pass out candidate.what type of certificate can i got in marine service.
how we explain parallel paths armature winding?
How to decide cable tray size?
