Interested to Buy Any Domain ? << Click Here >> for more details...
in thermal power plant the steam produced is made to cool
after falling on the turbine blades.
my question is why this is done while the same is needed to
heat up again.
"jab pani ko wapis garam hi karna hai to thanda kyu karte
hai"
- 11 Answers
- 18057 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / priya
because the super heated steam will be saturated. hence we
cool and then recycle it
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to calculate the phase to phase clearness of HT /// LT bus bar?????
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
What are the two types of compensation?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Explain the fundamental difference between emf (electro motive force) and pd (potential difference) ?
What is advantages of VSCF wind electrical system?
how the aircraft outer body and inner body is separated ?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
Is it true that in the 3 phase transformer, the limbs of the core are at 45 dgrees to each other. if true, why?
Can any one provide the inspection procedure of MIMIC for VFD panel? Details: If someone wants to have a mimic in the VFD panel what are inputs considered for the mimic(like on,off,trip) whether we are able to add speed variation in the mimic(if so how can we get) and what are the parameters to be checked in the MIMIC during inspection?
what is spadar bar .why I use in DC generator.
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
WHAT IS IM (INDEX OF MOUNTING )IN MOTORS
what do u understand about FACTS? how they are useful?
