Interested to Buy Any Domain ? << Click Here >> for more details...
which type of rtd is good for any system,2wire,3wire or 4
wire
- 9 Answers
- 15299 Views
- I also Faced
- E-Mail Answers
Answer Posted / s vedpathak
3 wire RTD (PT100)is good compare to 4 wire & 2 wire as the
lead wire compensation is achieved in it with less cost.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
Explain pH, Conductivity.
What is standard procedure of manual mapping in Radar type level transmitter?
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
How many ohms are required for proper earthing?
Why even multiple power supplu r used in instrumentation system?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
Why MUX JB's are using only Temperature Element in Fundation field bus?
Give Detail information about plc,dcs,and scada system?
What is heating effect?
What is super thermocoupal?
how to measure draft pressure in transmitter pl. give its single line digram
What is difference between Ionization heat and bimetallic heat
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
