Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / muneeb ahmad
it seems that it is due to form factor but Actually it is
not due to form factor,if there is necessarily multiple of
11 then how can we get 400,127 or etc etc....
i think by changing factors and certain conditions it is
possible to minor change in form factor then how we are
getting same form factor since the production of
electricity....
it is just a misconception of introduction of form factor....
| Is This Answer Correct ? | 3 Yes | 20 No |
Post New Answer View All Answers
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
What is principle of Floroscent tube 36watt.
What is tranformer differtial?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
what is the difference between circular wdg & ractangular wdg?
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
What is the function of NER and NET?
what is transformor oil gread
1.how many types of relays? 2.difference between ATS& STS?
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
why the value of k is more in shell typr transformers?
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
how to calculate the earth fault current
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
