Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vijay balu raskar
Power factor is ratio of active power to appearant power. we have to use capacitor bank to improve power factor.Also, removing inductive loads. As per power factor error.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why industry prefer ht motor instead of lt motor.
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
what may the reason for vector shift in a generator?
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
how to select the double earth conductor if 21A full load?
BRIEFLY EXPLAIN THE STORAGE CLASSES AND THEIR TYPES IN C
What are the uses of stepper motor?
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
How to find out damper winding failure for synchronous machine?
Where can i get practical knowledge of solar system?
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
