Interested to Buy Any Domain ? << Click Here >> for more details...
Dear Friends,
I have a 500KVA transformer supplying whole factory having
3 phase and single phase mixed loads. Power room has
ammeters connected via CTs for individual phase. Now I know
that readings shown on meter for each phase say R,Y and B
are line currents. But when I want to know the total on
transformer do I need to add the currents of all three
phases readings shown on meter or value for anyone phase
will give me the correct power load on transformer for that
point of time.
2. If ammeter shows unbalanced readings for R,Y, B phases
say 150, 250 and 300 respectively so can I assume that 150A
i.e average of 3 will be the 3phase load currents and
remaining will be 1phase currents. Please clarify my doubt.
- 4 Answers
- 7588 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Calculate load(KVA) on each phase and add
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
what is the difference between Central Battery System and UPS in applications and uses? and why UPS suitable for Computers and central battery for emergency lighting?
how the phase convertor changes the no. of phases
placement paper samples of mspl company
What is the feedback in the control system?
Why is back emf used for a DC motor? Highlight its significance.
What is the type of earth fault protection used in battery? explain.
is it possible to start a motor in felid connected to a remote mcc
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
Why do we need interlocking in a HT metering or Ring main unit switchgear?
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
bsec exam syllabus (mis)
