What is A check, B check, C Check & D check for a diesel
Generator? Please guide me as this question was asked many
times and till now i haven't get right answer.If you can mail
me then please mail me the answer @ yogiagarwal@gmail.com.
Answer Posted / anand
A check is daily check than B check is 6months or 350hourly
checking than C check is yearly 600 to 1200 hourely d check
is 1600 hourly
Is This Answer Correct ? | 319 Yes | 74 No |
Post New Answer View All Answers
how to identify the odd man out in the arranged particular type of object
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
What are the things to do when approaching the port?
Where can i see model papers for NLC graduate engineer test and RRB section engineer test
send me vizagsteel papers (m.t.. please.)
respected sir/madam.. i wish to know about the latest mechanical inventions and improvements... hwere can i get them... please respond to me through my id
As compression ratio increases, thermal n increases. How is thermal n affected by weak and rich mixture strength ?
What is representative elementary volume?
A fan is handling hot air at 285 degC with flow of 411635 m3/hr, power consumed is 1165kW and efficiency is 66%. what will happen to flow, power and efficiency of the fan if a water spray system is introduced to reduce the air temperature up to 200 degC? (also please refer any document regarding this)
sir i have applied for ntpc and engineers india can u suggest some books which have one words.
Draw L.O. system in diesel engine?
when do we use roller bearing, deep groove ball bearing, angular bearing, sealed bearing, semi sealed bearing, unsealed bearing, anti friction bearing, journal bearing, thrust bearing
What are steam turbine parts usually come into damage?
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
which material is suitable for punching press to avoid scratches amd waear of metal hittimg the blades?