What is the difference between HMI,SCADA and MMI,not
abbrevation?
- 7 Answers
- 37202 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / malik shams-ul-arfeen
HMI (Human Machine Interface) and MMI (Man Machine
Interface) are the same and have discussed earlier in
detail.
SCADA (Supervisory Control & Data Acusition) is a software
package which uses aur local control systems (eg. DCS or
PLC) to control or monitor " Our REMOTE location
installations"
If our Field (Hazerdouse area) and Control room (NON
Hazerdouse area) are is same geographical locations then we
dont have any need of SCADA.
But if our field and control room have different
geographical locations (Like main control room of
Offshores, gas plants / supply stations all over the
country etc) then we need SCADA integration with our MCR
control system.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
Explain PID, ON/OFF, Controls
how to relay switch sense the fault?
what diffrence b/w plc s7200,300,400
key exchanges in wpa,wpa2,tls
How to calibrate Field bus transmitter? procedure ?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
Difference between dcs and plc including date processing and architecture.
which type of filter gives the constant phase characteristics?
why is an oxygen sensor used in a boiler stack
Draw symbols of the following :
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
the output of the common trasmitter protocol in qatar gas are the following
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
