Answer Posted / saravanan.m

*Take one sample from top of Transformer and one from the
bottom of transformer.
*The BDV of oil should withstood min 50 KV
*The gap between the test sample is 2.5mm maintained
*Each sample(top/bottom) should be checked seperately
*Procedure
a.Voltage should be gradually increased from 0.
b.At one point Flash will take place and that point is
termed as Bread down Voltage.
*If its withstand means the viscosity of transformer oil is
good

what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.

2065

---

what is meant by directional earth fault and non directional earth fault? describe both.

1883

---

Salient pole alternator is more stable, why?

2686

---

what is the difference b/w ATS and HTS?

2150

---

suri transmission

4728

---

what are the installation procedure of high voltage power transformer,CT,CB&PT?

2046

---

what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end

2313

---

what is Different between Bilinear and Unilenier?

2114

---

How to calculate the heat load for a electrical room

3058

---

WHY IL=IPH IN STAR AND WHY IPH=IL/1.732 IN DELTA? WHAT IS REASON BEHIND IT?

6326

---

what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation

1960

---

What is the maximum percentage voltage drop (vd%)for a motor control center

1996

---

how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?

2875

---

would you please give me any idea about the BARC interview question on electrical? i have an interview on 1st july.....plz hlp me.......its urgent......

2449

---

Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.

2156

---