Interested to Buy Any Domain ? << Click Here >> for more details...
how to measure temperature from resistance of rtd?and how to
measure temp from voltage of thermocouple?is there any formulas?
- 3 Answers
- 10653 Views
- I also Faced
- E-Mail Answers
Answer Posted / jaywant joshi
During the measurement of Temperature from RTD, we have to
just disconnect the RTD from the control room,(as it is
externally powered, in case of thermocouple it is self
powered transducer) after disconnecting just measure
resistance of element e.g. 115 ohms.. then deduct 100 from
it...you will get say 15,,,then multiply this by 2.5..you
will get the temperature ,,approximately you will get 38
degrees..
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
List three types Level Gauges with their working principles
Why not come out analog output in ABB EL3020 when display show correct value
what are the use of belew gear in general ??
what is difference between fork type and capacitance type level switch. where it is using
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
it is possible to check the fail safe condition in pressure transmitter. if possible how?
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
Explain the working of an electronic level troll.
What is the use of temperature compensation?
what is RTV function in in process control?
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?
How to work togather like sov,limit switch,proxy switch and booster in xv
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
what is droop in governer ,type of droop ,how it work
