Answer Posted / ashish
In a parallel circuit, a charge does not pass through every
resistor; rather, it passes through a single resistor.
Thus, the entire voltage drop across that resistor must
match the battery voltage. It matters not whether the
charge passes through resistor 1, resistor 2, or resistor
3, the voltage drop across the resistor that it chooses to
pass through must equal the voltage of the battery.
Vbattery = V1 = V2 = V3 = ...
If three resistors are placed in parallel branches and
powered by a 12-volt battery, then the voltage drop across
each one of the three resistors is 12 volts. A charge
flowing through the circuit would only encounter one of
these three resistors and thus encounter a single voltage
drop of 12 volts.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
How much minimum insulation required between 11kv/3.3kv transformer windings?
kindly send me 11KV MV motor differential protection procedure by primary injection method.
What the main causes of transient interruptions on Over-Head Distribution Lines?
sir pls send the je exam - 2008 and other model question papers..
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
what is earth fault relay 64T, why it is used in main Incomer and neutral CT of Transformer.
can i able to get bhel previous exam question paper?
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
I am shobana from Chennai. I am having my personal interview on 19th Dec at Chennai.kindly mail me the questions to mail id shobana.shanthi@gmail.com
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
Draw the line diagram of diffretial relay connected to transformer?
