Sir
Power transformer :- (in generating station)
Alternator terminals side - Delta
HT transmission line side - Star
Why?
Answer Posted / bhim kumar yadav(l&t)
bcz in delta side voltage is more compare to star side. so
insulation cost is very-very high in delta side compared to
star side.therefor, we keep always star connection in HT
side
Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
How CFL &T5 tube light glows?
Why generation voltage in thermal power plant is between 11kv to 33kv?
difference bewteen reverse current and alternating current
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
how does high earth to neutral voltage affect electronic equipment?
primery try cell?
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
in dc shunt motor if field winding is shorted then
where the lexical paramater will use in fron end?
what will be project cost for 100 kv transformer connection under oyt scheme.
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory