Interested to Buy Any Domain ? << Click Here >> for more details...
What are the conditions to be satisfied before connecting
two DC generators in parallel?
- 9 Answers
- 17812 Views
- Bhel, Godrej, I also Faced
- E-Mail Answers
Answer Posted / bharat3832
those two machines should have same output voltage and in
same frequency
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
Why only sinusoidal ac voltages are generated?why not triangular or sawtooth?
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
why co incidence factor considered in transformer sizing?
can anyone explain 11kV 3core cable megger,hi pot test procedure with connection details?
What is evaporator & condencer & compressor
differnce between single acting and double acting solenoid valves
What current flows in the transformer primary when its secondary is open?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
If the feeder rating is 7.5 kw or 10 HP star-delta feeder, MCCB is taken as 63 a, contactors-32 a, how much will be the OLR rating or which range OLR should be considered when we concern about type-2 coordination?
What are the disadvantages of thermal power plant?
is it possible to test of bus bar in high rise building without completed full floor ?
