Interested to Buy Any Domain ? << Click Here >> for more details...
in thermal power plant the steam produced is made to cool
after falling on the turbine blades.
my question is why this is done while the same is needed to
heat up again.
"jab pani ko wapis garam hi karna hai to thanda kyu karte
hai"
- 11 Answers
- 18340 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / bharat3832
to have effecting heating
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
What is the function of RCBO? What are the different sensitivity ratings & each application?
1. What is the exact formula for one weber? for example,(one ampere = one coulomb electron of electrons crossing a point of conductor at one second. i.e, 1A=1Q/1sec)
what is tri state logic gate
Draw transformer phasor diagram.(full load,no load)
how could we know the size of cable by physical view?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
will 1050kva DG set withstand for back charge of 16MVA transformer
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
what is the formula for computing cable tray size & capacity
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
what happen when power factor of 2 parallely operated transformer become equle?
What are the advantages and disadvantages of closed-loop control system?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
