Interested to Buy Any Domain ? << Click Here >> for more details...
in thermal power plant the steam produced is made to cool
after falling on the turbine blades.
my question is why this is done while the same is needed to
heat up again.
"jab pani ko wapis garam hi karna hai to thanda kyu karte
hai"
- 11 Answers
- 17591 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / lalit vaidya
BECAUSE IT IS VERY DIFFICULT TO CONVERT ENERGY WITHOUT TEMP. DIFF. GREATER BE THE TEMP DIFF. GREATER WILL BE HEAT ENERGY CONVERTED IN TO MECH. ONE ACCORDING THERMODYNAMICS LAWS .
ALSO WHEN EFFICIENCY IS CONCERN LOW PRESSURE HEAT ENERGY GIVE MORE TURBINE OUTPUT HENCE IT HAS TO RECYCLE AGAIN
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
When can we take Neutral as common neutral link?
please send 5yearje solved papers on my email himmatsinghnathawat@gmail.com
In parallel operation time both NGR’s close or not close if both close what will happen
What is the maximum and minimum rating of UPS?
operation of protection relay watchdog contact?
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
How we select the vector group of 3phase power transformer?
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
what's the difference between 'shaft power demand' and 'BHP' , when we consider electrical load list.
What are the functions of different probes used in cro?
What is bridge rectifier and explain with details
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
how works inductive &capacitive sensors?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
