Interested to Buy Any Domain ? << Click Here >> for more details...
Consider a level troll.
i am getting a correct value in 4mA and 20mA.
the value in the middle(30 to 60%)is disturbed and i am not
getting the appropriate value.
what is the solution to normalize the level and to get the
correct value..
- 2 Answers
- 6241 Views
- KNPC, I also Faced
- E-Mail Answers
Answer Posted / amit
Just Simply Calibrate the transmitter With Different ranges
check for
0% should get 4mA
25% should get 8mA
50% should get 12mA
75% should get 16mA
100% should get 20mA
take reading from Increasing and decreasing Reading. And
According to which plz Set ZERO or SPAN.
| Is This Answer Correct ? | 1 Yes | 8 No |
Post New Answer View All Answers
How INtools is useful for routine Instrument maintenance?
key exchanges in wpa,wpa2,tls
where proximity sensor installed on tank in loading arm application
How does work A temperature valve or fv control valve in process plz brief me
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
Which type of pressure can be measured by primary elements?
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
Pl send the model question paper of mahagenco account officer post
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
What is the differerence between hysterisis and linearity.
How to calibrate H2s Dectector
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
What is difference between radial vibration and axial vibration explain in detail .
Using your own examples solve a problem involving normal table. (experimental method and analysis)
