Interested to Buy Any Domain ? << Click Here >> for more details...
What is deffrence between Battery and capacitor
- 3 Answers
- 9318 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / viswanath
all capacitors hav equal
charge on both plates so
same potential .but bot
electrodes of battery in
most of the cases r not
of same potential.a
curent flows inside a
batery too.but actualy
conduction taks place in
cptor thru electrostatic
induction.and some btry
once discharge cant b
rechargd
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How d.p. Transmitter can be applied to open tank?
how to calculate the total flow in square root
pls give me presant awerness quistion and answer in my emailid.
any questions on motor and energy conversions machines?
what is wave length were using ?
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
What is instrumentation instrumentation engineering?
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
what is the procedure of belt scale calibration?
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
How to Calibrate Interface Level Troll in field
i am having information technology branh ....... can i prepare for psu exam
