Interested to Buy Any Domain ? << Click Here >> for more details...
If i want to build 230kv substation what are the equipments
to be installed?
- 7 Answers
- 16687 Views
- I also Faced
- E-Mail Answers
Answer Posted / karthik.g
if you want to install 230kv substation you need to have
following equipments....
1.100MVA Transfomer
2.220 & 110 CB,CT,PT,Isolator,C&R Panels,LA,Insulator
3.PLCC equipments (if need)
4.110V & 50 V LT Switchgear
5.110V & 50V Battery & Charger
6.steel structure (for equipment erection)
7.120KN Disc Insulators (Normal)
8.Al.Bus Bar
9.Insulator hardware
10.Bolts & NUts
11.Conductor
12.earth wire
13.connectors
14.Marshaling Boxes & junction Boxes
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
what are the principles of a booster converter?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
The screw thread commonly used for transmission of motion is one of the following types of threads
What is the difference between the impedance percent and impedance voltage ?
what is spadar bar .why I use in DC generator.
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
how to enter inverter parameter? without manaual?
what is servo motor and how to work it.
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
can mini-curcuit supply MIL-tested transformer !
how to calculate short circuit current for the busbar
what r the safety measures in UPS ? explain all?
what will be the effect if you were using different brands of outlets?
