Interested to Buy Any Domain ? << Click Here >> for more details...
why we use the fuse in only one wire? althrough in ac
current the current flows in both directions.
why the neutral wire can be taken half the magnitude of
phase wire while same current returns from neutral wire?
- 2 Answers
- 5017 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / ghanshyam singh
i think the rating of device in which the fuse is used has
more capacity than the rating of fuse,therefore it can be
considered that the fuse will blow out first and the device
will be saved.
by ohms law v is proportional to i so i think the
current decreases through the neutral wire but i dont
know that haps in the second half cycle of ac currrent
| Is This Answer Correct ? | 0 Yes | 10 No |
Post New Answer View All Answers
what is the difference between droop mode and ischnorous mode in thermal powerplant?
How to calculate mf when meter equipment and meter are connected
Explain the process of commutation in a dc machine.
why we are not giving the zone 1 trip command to the master trip relay
What mean by MLTP
THERMAL CAPACITANCE IS MEASURED IN..................................................
Define reserve-generating capacity?
How to Decide(calculate) Bush bar size for copper and aluminiam ?
Direction of flow of active power and reactive power with logic?
hi,every one, i have to write the search paper on "performance policy optimization" of NGN (next generation networks). i need the material on this topic. can any body help me. please tell me any useful site where the good material is available and name of any reference book. it should be a great help for me.
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
what are the preventive maintanance actions taken for air circuit breaker? please answer me
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
