Answer Posted / abdul
earthing: to provide low impedence path for currents to flow
grounding: to provide ref or zero voltage to a network
Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
What is a single phase autotransformer?
how to do the ductor test?
Why colled 440V to 3-phase supply.
what is the practical application of full adder circuit?
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com
how single phase preventer works ?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
What is the necessary and sufficient condition for stability.
If short circuit ratio is high is it bad or good for a machine then tell the reason...
how we can set the IDMT relay.
How is the speed of a DC shunt motor related to the armature current?
What is the main cause of magnetism?