Interested to Buy Any Domain ? << Click Here >> for more details...
HOW THE AC GENARATOR CAN GENARATE REACTIVE POWER,HOW CAN WE
CONTROL IT.AND OTHER SOURSES OF REACTIVE POWER GENARATIONS
ARE WHAT.
- 3 Answers
- 5618 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Reactive of generator can be controlled if is connected to
grid/ network, by varying the excitation.If the gen
terminal voltage is higher than the grid voltage ,reactive
power is positive ( lagging) and the vice versa
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
in dc shunt motor if field winding is shorted then
What is the difference between Droop vs Isoch Control?
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
What is non-minimum phase transfer function?
What is the formula to calculate distribution transformer De-rating on iron losses basis
In CTs tan delta point should be earthed , what is the reason behind it?
How can we convert 11 kv to 440 volt without using transformer ?
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
How to distinguish whether MCB is DC or AC looking at it physically
How many sprinklers should be in one pipe line?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
On Which Pressure PRV is operated.
How to decide whether A / B / C / D curve type MCB should be used?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
