If we know the N - Value of soil and required bearing
capacity how do we know what diameter and length of pile to
be casted?
How can we check whether the dia. and lenght of pile we
have selected are most economical onse?
- 3 Answers
- 6085 Views
- I also Faced
- E-Mail Answers
Answer Posted / sard
First of all
If N values are available , lot of correlations are
available to find out the angle of internal resistance
Now from angle of internal resistance find out the pile
capacity using static formula
Now if pile capacity is more than the much more than the
factored stress acting over the pile cap . its uneconomical
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is the water cement ratio? how to calculate it? list the wt. of constructions materials including concrete both ordinary and light wt. concrete
Suppose you planning to paint newly fabricated workshop building made of structural steel of 10 tons total mass. How many litters paint primer for 1 coat and 2 coat of top coat?
What is meant by autocad?
how many types of survey and what are levelling instrument?
In few lines, please be elaborative on extras and talents that make you a potential candidate for the post:
What is the significance of cost estimate knowledge for an architect?
how much cost of single coat 20mm thick plastering per sqre meter
Rate analysis for construction of a solid block masonary of size 400x200x200 in C.M.1:5 in superstructure .Compressive strength 5.00 N/Sq.mm Confirming to IS: 12894:1990, with necessary scaffolding, raking of joints and pointing the same. I require rate per Cum.
Could you please give me an answer to the mixing proportion of concrete M1 grade (sterngth of 1 MPa)?
Would you cause a 55-gallon drum of water to weigh more by climbing in?
What is the largest concrete dam in the world?
what is the specific gravity of rubble in plum concert
What is Grid floor and mention its advantages ?
what is the max. and mim. height of vertical post in informatry sign board which is used in highway projects.
What tor stands for in tor steel?
