Interested to Buy Any Domain ? << Click Here >> for more details...
If a differential pressure transmitter is calibrated for
0~2500 mmH2o and transmits a 4~20mA dc signal. The
transmitter is placed across an orifice plate which is sized
to create 2500 mmH2o differential at 5000m3/Hr
a) what is the flow rate when the transmitter signal is
13.0mA DC?
b) what is the signal output of the transmitter when flow
rate is 2500 m3/Hr ?
- 5 Answers
- 24947 Views
- I also Faced
- E-Mail Answers
Answer Posted / mani
a)Ans 4062 m3/hr
b)Ans 8 mA
| Is This Answer Correct ? | 6 Yes | 11 No |
Post New Answer View All Answers
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
What is zone,loop/fire alarm system?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
how the arrangement of equipments done in control room
Programmable Logic control.
what is function of SCADA , and how is it work, explain with difination
In turbine what does term CDP, NI, NH, HSSOC means.
How to work togather like sov,limit switch,proxy switch and booster in xv
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
what is the reason while warning lamp is on while the engine is cranking?
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
