Interested to Buy Any Domain ? << Click Here >> for more details...
What is the tolerence limit between neutral and earth in
230 V AC System?
- 7 Answers
- 11155 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / mukund
They Should be at same potential, Hence no tolarance is
required
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
Differenciate between circuit wiring and sub main wiring with illustrations
full form of flry b
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
why the arc welding machines require parallel earthing systems? ie why each machines are connected to earth pit by separate wires during earthing? wats it adavantages?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
can any one tell in easy method for circulating current ??
How PSV sizing being done
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
How will polarity test of Dy5 Transformer ?
how a flip flop can be used as a latch?
What is miller crystal oscillator? Explain its operation?
