Answer Posted / a. nagaraja

Refractory work will be done in the boiler at the bottom
four sides, manhole doors,burner area, peephole area and at
the top of the boiler. To heat the refractory from low
temp. to high temp, slow firing is done. So that
refractory will be gripped. And also to remove the
unwanted particles like sand, rust, oil and others from
boiler tubes and headers slow firing is done.

TSP and NaoH chemicals will be added with D.M water and it
will be filled in the boiler. The prs. will raise slowly
up to max. 15kg/sq.cm

What is the most basic characteristic of supercritical boilers?

1246

---

what is air intake system

2048

---

find the damper capacity of a system having a damping co efficient of 90% with a vibrating mass of 0.1Kg over a spring having a stiffness of 1KN/m.

1875

---

If a person is working in R&D organisation but he has not been involved in R&D activities. So Which types of questions may be asked if he wants to get opporunity in mechanical R&D activities?

3462

---

What is the role of nitrogen in welding?

1298

---

What is the difference between the flight of a plane and a helicopter?

1160

---

how we calculate the induced air capacity of id fan of a boiler?

2397

---

What is a steam turbine diaphragm?

1154

---

List out the points of diesel generator B check?

2167

---

how to define nomenclature of bearing.

2266

---

The efficiency of a pin fin with insulated tip is

1848

---

Sir, I'm P.Ravi Kumar want to previous mechanical Question Papers for rrb exam

1960

---

Causes of M/E high exhaust valve temperature

2073

---

Hiii.. i have applied for steel plant management trainee 2010 exam for stream mechanical... the pattern of the exam has changed.. a preliminary exam which consists of the engineering basics... can any one suggest any book for this... kindly respond to this...

1891

---

as started in the job offer notification, is our basic salary of 1lakh good for you if employed?

1780

---