IS RTCC AND OLTC REQUIRED FOR 500 KVA 11KV/433V TRANSFORMER
FOR AN INDUSTRY?
- 7 Answers
- 16212 Views
- IGCAR, TNEB Tamil Nadu Electricity Board, I also Faced
- E-Mail Answers
Answer Posted / bala.a
it will be based on the voltage Fluctuation report/ survey
of your factory. if you consider onload /off load tap
changer u should consider RTCC/ OLTC
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What is the difference between hot and cold loop testing?
how to check avr of dg set of 125kva
What is clock position of Transformer?what are the clock positions are there?and what is different of them?
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
what is the value of combined earthing in general electrical circiut?
define as synchronous generator
I need HT sphere gap calibration table. Can any body help me.
What are the functions of temperature scanner in power transformer?
Can u tell me design of switch yard
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
what is the working process of over & under voltage relay.
DG Earth Value?
What is formula calculation size cable wire ?
sir, Is their any measuring unit of knoking? please explian?
