Interested to Buy Any Domain ? << Click Here >> for more details...
what is kvarh? Please difine it With calculation
- 3 Answers
- 24596 Views
- GM General Motors, I also Faced
- E-Mail Answers
Answer Posted / kailash
In General , KW = V*I*Cos Phi ( Actual Power ), KVA = V *I (
Apparent Power ), KVAR = V*I*Sin Phi it denotes reactive power
| Is This Answer Correct ? | 41 Yes | 3 No |
Post New Answer View All Answers
what is invertor supply and raw powersupply
what are the available sizes of pin type terminal lugs in the market today?
What is the role of Dedicated earthing in UPS System?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
what is the difference between skin effect
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
What is the permissible maximum flux density in transformer core?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how does a shunt reactor maintains the bus voltage???
Why synchronous motor is used in power factor improvement,dc series in lift
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
What about electrical Units. discrive in detail
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
