What are the causes of failure of foundations and remedial
measures?
Answer Posted / santo okello
There are various causes of failure of foundations;viz
1-Uneven loading of the structre.
2-poor selection of the foundation due to wrong or lack of
soil analysis
3-poor drainage system within the site.
Remedies
1-for uneven loading,during design state,live and dead
loads should be carefully distributed by introduction of
columns,beams.
2-proper soil analysis should be carried out,this will give
the inside of the type of foundation to be adapted for a
particular structure.
3-for poor drainage,this can be avoided by proper leveling
of the site prior to construction,use of land drains or use
of water repellant cement for the foundation concrete
| Is This Answer Correct ? | 25 Yes | 4 No |
Post New Answer View All Answers
how the calculation occurs if i want to mix 1cum of M50 concrete. please calculate every ingredients with detail calculation.
What is limit state method and working stress method and ultimate method
How to calculate Cement in bags ,sand in sqft and aggregate in sqft for 1cum M25 grade concrete
What is rate for brick masonry work of 1.0 m3 in cm 1:6?
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
TELL ME THE EQUATION FOR OGEE SPILLWAY
How many lbs are there in a yard?
what are the ffactors you considered choosing the course?
i need gate exam civil engineering question papers with answers
what's the formula for calculate pcc for matt(45mm aggregate)?
GIVE US DETAIL OF YOUR PRESENT EMPLOYMENT STATUS?
What are the composition of a landfill?
What is the standard volume of pharma in cub ft
Special thing in designing a overhead reservoir ? which is different from an ordinary design
When was the first motorway built in england?