Interested to Buy Any Domain ? << Click Here >> for more details...
in the pipe line if the control valve fails to respond to
controller action,by what means we can stop the flow in the
pipe line ?
- 9 Answers
- 11827 Views
- I also Faced
- E-Mail Answers
Answer Posted / thiagaraj
thnx priya;ranjith.nilmaheshin nd karthi
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What are the application of bernoulli’s theorem?
What is first echo & echo window in radar type level transmitter?
i am having information technology branh ....... can i prepare for psu exam
What is the differerence between hysterisis and linearity.
How to Calibrate Temperature Switch in field
what is function of SCADA , and how is it work, explain with difination
What is the use of temperature compensation?
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
How servomotor controls throttle valve of TURBINE?
Make Heater Process Logic.
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
where proximity sensor installed on tank in loading arm application
